Saturday, September 24, 2022

Rafters

 Rather than trusses, I am using 2x12 boards 20 feet long as rafters. These bad boys are heavy and awkward. The first 2 took about 3 hours to figure out how to install. Then I was able to get a process in place and it went smooth. I used a strap to hold the top end as I lifted in increments until it reached the ridge beam. 



This was the key. Strapping the top end to hold in place as I lifted in increments 


Rafter making 


at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Front Door Entry Steps

 This was my first attempt at gluing and clamping, to make large wood planks. I was surprised how easy it was, although I probably did not d...

  • Ridge Beam
     Sitting on top of the four posts is the ridge beam, consisting of two 2x12 LVL engineered wood connected together to make a 4x12 . I was ab...
  • Rafters
     Rather than trusses, I am using 2x12 boards 20 feet long as rafters. These bad boys are heavy and awkward. The first 2 took about 3 hours t...
  • Eves
    Like the roof, I decided the eaves needed to be done by someone other than me. It is just too far off the ground and quality is critical. I ...